Wiper Insert

• Improving Surface Finish

Under the same machining conditions as conventional breakers, but with the feed rate increased, the surface finish of the workpiece can be improved.​​​​​​​

• Improving Efficiency

High feed rates not only shorten machining times but also make it possible to combine roughing and finishing operations.

• Increased Tool Life

When a change to high feed conditions, the time required to cut one component is decreased, thus more parts can be machined with each insert. In addition, the high feed rate prevents rubbing, therefore, delaying the progression of wear and increasing the tool life of the insert.

• Improving Chip Control

Under high feed conditions, the chips generated become thicker and are more easily broken, thus, chip control is improved.

A standard holders can be used.
(*A double clamp, high rigidity tool is recommended.)

Use a holder with end cutting angle 93° for improving wiper
efficiency. A holder with end cutting angle 91° can improve wiper efficiency, however, there is no wiper efficiency with other end cutting angles (60°, 90°,107°etc.).